Some brief theory and typical measurements of phase noise. How to produce the lowest phase noise at a PLL output. A standard design procedure for a typical Type 2, second-order loop. As stated in ...
How Stable is your Op Amp or FDA design? One of the most important aspects of any end system design is to understand and improve (if necessary) the nominal phase margin for each stage. Since the early ...
Hosted on MSN
Researchers observe a phase transition in a 1D chain of atoms using a quantum simulator
Phase transitions, shifts between different states of matter, are widely explored physical phenomena. So far, these transitions have primarily been studied in three-dimensional (3D) and ...
In this paper, the design and simulation of Intelligent Prepaid Energy Meter (IPEM) has been presented. The objectives of this paper are: to model an IPEM, to show its reliability on load measurement ...
The course consists of three weeks of materials and is focused on modeling and control of grid-tied power electronics. Upon completion of the course, you will be able to understand, analyze, model, ...
Tools aid scale-up and comparison of single-use and stainless-steel bioreactors. Scale-up (and down) modeling of bioreactors is a valuable tool to support process characterization and improvement in a ...
Some brief theory and typical measurements of phase noise. Standard analysis of PLL phase noise used by most CAD applications. How to produce the lowest phase noise at a PLL output. A standard design ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results